I plan to replace all four intake gaskets (time's up...) and last I did it remember challenge involved in pulling down on the tube to create a gap big enough to properly clean all of the old gasket off.
Pulling the intake tube out of the intake hose (part 69603) would allow unfettered access to the cylinder flange and make installing the gasket much cleaner and easier. Question is, would that damage the intake hose and require its replacement?
Experiences, opinions?
Pulling the intake tube out of the intake hose (part 69603) would allow unfettered access to the cylinder flange and make installing the gasket much cleaner and easier. Question is, would that damage the intake hose and require its replacement?
Experiences, opinions?