Hi All,
i have the vetterman 4-2 exhaust. the two exit pipes are secured as per instruction... using these rubber tubes that are connect to steel rods (that are flared at the ends) via hose clamps. at some point the left exhaust pipe started moving slowly downwards, secured that with additional hose clamps and it seems to hold. then the other pipe was moving and i did the same on that part but it still moves.
is there anything better than these hose clamps?
Cheers
Kay
PS: don't know if that thread belongs to maintainance section or so.
i have the vetterman 4-2 exhaust. the two exit pipes are secured as per instruction... using these rubber tubes that are connect to steel rods (that are flared at the ends) via hose clamps. at some point the left exhaust pipe started moving slowly downwards, secured that with additional hose clamps and it seems to hold. then the other pipe was moving and i did the same on that part but it still moves.
is there anything better than these hose clamps?
Cheers
Kay
PS: don't know if that thread belongs to maintainance section or so.
Last edited: