I have a few questions please.
RV10 with dual Dynon Skyview and Dual ADAHRS, with two OAT sensors.
I have erratic OAT readings. Sometime it is ok and sometimes it will go down close to 0 Degrees C where I know it should read much higher. Trying to pinpoint the problem.
Will an OAT sensor installed inside a naca duct feeding the overhead ventilation, be accurate?
Secondly how will paint influence the accuracy of the OAT sensor?
The manual states that the system will automatically choose which sensor to use? Will it switch between the two sources?
Thank you.
RV10 with dual Dynon Skyview and Dual ADAHRS, with two OAT sensors.
I have erratic OAT readings. Sometime it is ok and sometimes it will go down close to 0 Degrees C where I know it should read much higher. Trying to pinpoint the problem.
Will an OAT sensor installed inside a naca duct feeding the overhead ventilation, be accurate?
Secondly how will paint influence the accuracy of the OAT sensor?
The manual states that the system will automatically choose which sensor to use? Will it switch between the two sources?
Thank you.
Last edited: