Originally Posted by Coaltowngarage
Its an early 90s kit, I haven't purchased the finishing kit yet. I had found a mount and gear legs someone was getting rid of for an engine change, but now that i'm actively looking there doesn't seem to be any popping up. I have found a set of gear legs and my question is, are they usable if I buy an engine mount separately?
The engine mount can be ordered undrilled, but trying to match an undrilled mount to drilled legs would be difficult. If you go this route, I would plan to switch to using taper bolts so you have some leeway to ream imperfect holes.
Or is your intent to get used legs from one project and a used mount from another project? If so, the later hardware will likely match up, but I would still plan to use the taper bolts or an oversize bolt so you can match-ream them.