From page 08-12:
Step 1: Rivet the HS-00901-1 Skins to the flanges of the Front Spar Assembly using the rivets called out on Page 08-13 Figure 1. Make sure to capture the flanges of the HS-904 and HS-1004 Inspar Ribs where they joggle under the flanges of the Front Spar Assembly.
I have the HS laying flat on the table since it's easier to reach the inside locations with the bucking bar that way. But, is the intent here to first rivet the top side flange rivets and then switching over to the bottom side flange rivets, and so on with the additional riveting? That would probably be better accomplished with the HS standing vertically in the cradles.
Thoughts, anyone?
Thanks. Mike D.
Step 1: Rivet the HS-00901-1 Skins to the flanges of the Front Spar Assembly using the rivets called out on Page 08-13 Figure 1. Make sure to capture the flanges of the HS-904 and HS-1004 Inspar Ribs where they joggle under the flanges of the Front Spar Assembly.
I have the HS laying flat on the table since it's easier to reach the inside locations with the bucking bar that way. But, is the intent here to first rivet the top side flange rivets and then switching over to the bottom side flange rivets, and so on with the additional riveting? That would probably be better accomplished with the HS standing vertically in the cradles.
Thoughts, anyone?
Thanks. Mike D.