tx_jayhawk
Well Known Member
THis is the 5/8 - 18 thread probe. It has the copper crush washer. I've snugged it down as tight as I dare, and I still seem to be getting a little leakage from under the probe.
It is "standard" (not pipe) threads, so I do not think one should technically be installing thread sealant on it. That said...I still seem to have a problem with a very small leak.
What have others done? If you used sealant, what type?
Thanks,
Scott
It is "standard" (not pipe) threads, so I do not think one should technically be installing thread sealant on it. That said...I still seem to have a problem with a very small leak.
What have others done? If you used sealant, what type?
Thanks,
Scott