Hi all
Just working on the left air ramp baffling (RV10) and realized I need to rotate the control arm on my MT P-860-3 governor. From what I see/read in the governor manual, it appears I just need to remove the 6 screws and rotate the face plate to the next set of screw holes, (approx. 60 degrees clockwise) to position the control arm properly for the push/pull prop cable.
Anyone have recent experience doing this?
My searching of the archives did not reveal a lot of details.
Regards,
Rick
#40956
Southampton, ont
Just working on the left air ramp baffling (RV10) and realized I need to rotate the control arm on my MT P-860-3 governor. From what I see/read in the governor manual, it appears I just need to remove the 6 screws and rotate the face plate to the next set of screw holes, (approx. 60 degrees clockwise) to position the control arm properly for the push/pull prop cable.
Anyone have recent experience doing this?
My searching of the archives did not reveal a lot of details.
Regards,
Rick
#40956
Southampton, ont