Hi,
There is a tooling hole in the W-631A aft canopy frame channel which rivets to the WD-725 side weldment. There is two holes that are opened up for a AN3 bolt that secures the canopy lug to the aft channel and side weldment (The two center holes in the picture below). The problem is there is a tooling hole in the aft channel just 1/8 to 1/4 away. This won't meet edge distance to the tooling hole. What has everyone else done?
Thanks
Vince
There is a tooling hole in the W-631A aft canopy frame channel which rivets to the WD-725 side weldment. There is two holes that are opened up for a AN3 bolt that secures the canopy lug to the aft channel and side weldment (The two center holes in the picture below). The problem is there is a tooling hole in the aft channel just 1/8 to 1/4 away. This won't meet edge distance to the tooling hole. What has everyone else done?
Thanks
Vince