Can anyone offer some guidance on fitting the canopy frame? Specifically, the gap between the canopy frame and roll bar?
I have my canopy frame installed with the anchor pin centered properly. When I close the canopy with the frame rollers all the way to the front (not on the roll bar frame) I have a 1/4" larger gap between the frame and the roll bar on the right side than I do on the left.
The left side gap is about 3/16" and the right side is about 3/8" to 1/2". I was planning on cutting my canopy today, but after looking at this I am not comfortable with that much difference between the two sides.
I tried to apply a little "muscle power" to the situation, but based on the geometry of the frame, that is a pretty difficult adjustment to make.
Is a gap of that size acceptable? Does anyone have a suggestion how to fix it? I appreciate anyone's input.
I have my canopy frame installed with the anchor pin centered properly. When I close the canopy with the frame rollers all the way to the front (not on the roll bar frame) I have a 1/4" larger gap between the frame and the roll bar on the right side than I do on the left.
The left side gap is about 3/16" and the right side is about 3/8" to 1/2". I was planning on cutting my canopy today, but after looking at this I am not comfortable with that much difference between the two sides.
I tried to apply a little "muscle power" to the situation, but based on the geometry of the frame, that is a pretty difficult adjustment to make.
Is a gap of that size acceptable? Does anyone have a suggestion how to fix it? I appreciate anyone's input.