Dear all,
I am currently in Phase 1 and do a lot of airwork.
What is quite bothering at the moment is that the stall warning remains on for about 15-20sec even after stall recovery.
I`ve installed the Vans supplied stall warning kit and wired it into a discrete input on the G3X.
Is there a timer in the G3X which says that the stallwarning shall remain on for a certain amount of time? I could not find something like this in the installation manual.
Or is my stall-vane too long? I left it as long as it was supplied..
Best Regards,
Yves
I am currently in Phase 1 and do a lot of airwork.
What is quite bothering at the moment is that the stall warning remains on for about 15-20sec even after stall recovery.
I`ve installed the Vans supplied stall warning kit and wired it into a discrete input on the G3X.
Is there a timer in the G3X which says that the stallwarning shall remain on for a certain amount of time? I could not find something like this in the installation manual.
Or is my stall-vane too long? I left it as long as it was supplied..
Best Regards,
Yves