Resolved . See bottom post
I was preparing to rivet the two remaining inboard ribs to my fuel tanks and realized i should not have riveted in two spots on each tank attach assembly.
I missed that note....grrr.
Some additional pics below. I need to remove the proseal and those rivets so i can then rivet the inboard ribs. How to best do that? I’ve not yet had to remove rivets that have cured a few weeks in proseal. I did previously bought PolyGone 310-AG sealant remover but interested in how others more exprienced would tackle this. (have not used PolyGone yet either).
This is the needed humility as I’ve been saying “wow, tanks really haven’t been that bad.” to myself recently.
Many thanks as always for your counsel.
I was preparing to rivet the two remaining inboard ribs to my fuel tanks and realized i should not have riveted in two spots on each tank attach assembly.
I missed that note....grrr.
Some additional pics below. I need to remove the proseal and those rivets so i can then rivet the inboard ribs. How to best do that? I’ve not yet had to remove rivets that have cured a few weeks in proseal. I did previously bought PolyGone 310-AG sealant remover but interested in how others more exprienced would tackle this. (have not used PolyGone yet either).
This is the needed humility as I’ve been saying “wow, tanks really haven’t been that bad.” to myself recently.
Many thanks as always for your counsel.
Last edited: