georgemohr
Well Known Member
Hi all!
Have a look at my proposed wiring harness between the GMU 22 in my left wing, and the primary GSU 25. The G3X install guide suggests that the cannon plug has two pins called "SIGNAL GROUND" (pin 1 and 3). My best guess here, since the book also calls for a 2-conductor and 3-conductor shielded wire, is that these two SIGNAL GROUND pins get routed to the shielding, and ultimately drained to the J252 connecter backshell on the GSU 25.
1) Is that right?
2) If so, is there any specificity about which SIGNAL GROUND goes with which conductors? I suspect not since they all get grounded together, but...
Thanks!
George
Have a look at my proposed wiring harness between the GMU 22 in my left wing, and the primary GSU 25. The G3X install guide suggests that the cannon plug has two pins called "SIGNAL GROUND" (pin 1 and 3). My best guess here, since the book also calls for a 2-conductor and 3-conductor shielded wire, is that these two SIGNAL GROUND pins get routed to the shielding, and ultimately drained to the J252 connecter backshell on the GSU 25.
1) Is that right?
2) If so, is there any specificity about which SIGNAL GROUND goes with which conductors? I suspect not since they all get grounded together, but...
Thanks!
George
Attachments
Last edited: