tx_jayhawk
Well Known Member
I have my float wiring running through a small (separate) hole in the fuel pickup tube grommet. Is it considered acceptable to secure that wire to the pickup tube before it connects to the floats?
I am assuming one would not want to tie wrap direct to the pickup tube, I was thinking of putting a small strip of silicone tape around the tube then around the wire to secure it.
Thanks,
Scott
7A
I am assuming one would not want to tie wrap direct to the pickup tube, I was thinking of putting a small strip of silicone tape around the tube then around the wire to secure it.
Thanks,
Scott
7A