StaringSkyward
Member
Howdy,
After years of lurking I've decided I need to jump in and ask a question and it goes like this:
I am assembling the rear spars on my slow build -9. There are two reinforcement plates that are match drilled to the spar where the flap and aileron hinges attach. Does the spar flange and the flanges of these plates need to be dimpled before they are assembled so the wing skin rivets can sit in them later? The plans don't mention it when describing the assembly of them.
Thanks,
Matt
Sloow build RV-9
Sheffield, UK
After years of lurking I've decided I need to jump in and ask a question and it goes like this:
I am assembling the rear spars on my slow build -9. There are two reinforcement plates that are match drilled to the spar where the flap and aileron hinges attach. Does the spar flange and the flanges of these plates need to be dimpled before they are assembled so the wing skin rivets can sit in them later? The plans don't mention it when describing the assembly of them.
Thanks,
Matt
Sloow build RV-9
Sheffield, UK