Hi all,
I installed a tru-trak roll servo in the recommended position under the floor in an RV 8. I am in the wiring phase and was installing the 9 pin sub-d connector. I find that the sub-d housing is very close to rubbing against the aileron push tube. I can't think that touching that or even gettting close would be a good idea. How have others dealt with this? Is there a right angle sub-d housing?
For that matter, I have a bunch of wirings going through the spar center section that are going to run right under the aileron push tubes. How have others secured those down so there is no chafing?
Regards,
Michael Wynn
RV 8 Wiring
San Ramon, CA
I installed a tru-trak roll servo in the recommended position under the floor in an RV 8. I am in the wiring phase and was installing the 9 pin sub-d connector. I find that the sub-d housing is very close to rubbing against the aileron push tube. I can't think that touching that or even gettting close would be a good idea. How have others dealt with this? Is there a right angle sub-d housing?
For that matter, I have a bunch of wirings going through the spar center section that are going to run right under the aileron push tubes. How have others secured those down so there is no chafing?
Regards,
Michael Wynn
RV 8 Wiring
San Ramon, CA