Mike S
Senior Curmudgeon
I just fired up the TruTrack A/P in our new project a couple days ago-----and the readout screen is Kaput. A few pixels are lighting up, but not enough to be able to read.
I seem to recall that there was an issue with this a few years back, and I believe someone found a way to repair the readout.
But, after almost an hour of searching both VAF, and Google, no joy.
This is a flat pack Digiflight II, GSVG.
Any ideas out there?
Thanks in advance.
I seem to recall that there was an issue with this a few years back, and I believe someone found a way to repair the readout.
But, after almost an hour of searching both VAF, and Google, no joy.
This is a flat pack Digiflight II, GSVG.
Any ideas out there?
Thanks in advance.