Dynon has addressed this capability on the Skyview forum, there is no internal feature you can access to accomplish this. Their recommendation is to use the RS232 data output to a device that would figure out the condition and alarm as needed. Something like a Raspberry Pi would work well if you want to program the condition logic and connect the audio out to the intercom.
There is an RV-12 mod that featured a microswitch to monitor flaps up or down; post #119 at
https://vansairforce.net/community/s...=64145&page=12.
If you want to use the internal Dynon functions, you could do something like the flap position microswitch wired in series with an air speed switch from Aircraft Extras wired to a Dynon SV monitored contact pin. You could set the switch to activate at 80 kts and monitor the flap handle position with the microswitch on/off to complete the circuit. You could setup a Dynon FLAPS widget to show a RED/GREEN/YELLOW condition if the airspeed is over 80 knots and the flaps are down. The choice of a open circuit or closed circuit would depend on the microswitch NO or NC configuration with the airspeed switch state.
John Salak
RV-12 N896HS