Hello,
Hope everyone had a good X-mass.
I started installing my panel and I have a question. In the radio stack I have from top to bottom
340 audio panel
XL 250
SL 40
327 transponder
I have one angle riveted to the panel and one angle screwed to the rear most holes that will still line up with all the trays. The SL 40 tray is by far the deepest and is about a half inch above the subpanel support. so the question is if I support just the SL 40 tray to the subpanel will that be enough for the rest of the stack?
Thanks Matt
Below are the links to the pictures.
http://img18.imageshack.us/i/hpim0830.jpg/
http://img208.imageshack.us/i/hpim0831f.jpg/
Hope everyone had a good X-mass.
I started installing my panel and I have a question. In the radio stack I have from top to bottom
340 audio panel
XL 250
SL 40
327 transponder
I have one angle riveted to the panel and one angle screwed to the rear most holes that will still line up with all the trays. The SL 40 tray is by far the deepest and is about a half inch above the subpanel support. so the question is if I support just the SL 40 tray to the subpanel will that be enough for the rest of the stack?
Thanks Matt
Below are the links to the pictures.
http://img18.imageshack.us/i/hpim0830.jpg/
http://img208.imageshack.us/i/hpim0831f.jpg/
Last edited: