I made an incidence tool from two pieces of angle aluminum. One long piece, one a little longer than the desired block dimension.
Clamp them together perfectly square and at the correct dimension. Easy to carry it back and forth and place a level on top.
Estes Park, CO
wirejock at yahoo dot com
Donated 01/01/2021, plus a little extra.
RV-7A #73391, N511RV reserved (2,000+ hours)
Empennage, wings, fuse, finishing kit, now FWF
I cannot be, nor will I be, held responsible if you try to do the same things I do and it does not work and/or causes you loss, injury, or even death in the process.