I usually rout wires through ribs using snap bushings. But, sometimes bits come pre-terminated, as is the case with the Dynon pitot tube and heater control. So, I just routed the wires through the lightening hole in the rib with 3M mounts in strategic points to keep the wires away from sharp edges.
I am not completely satisfied with this 'solution', and am wondering if there is a better way without cutting off the terminals and routing through bushings. I'll do that, if not, but one of the terminals in this case is a micro molex, which I hate to have to reassemble with my micro molex skills.
I am not completely satisfied with this 'solution', and am wondering if there is a better way without cutting off the terminals and routing through bushings. I'll do that, if not, but one of the terminals in this case is a micro molex, which I hate to have to reassemble with my micro molex skills.