Longeron bend is not flush with the skin

I drilled my longerons yesterday and discovered my bend under the F-704 apparently was a little off. I ended up with top of the longeron being high by about 1/16th. Everything looked fine before I started drilling. At the time I figured it would be okay so I continued on, but now I'm worried about it. Is this going to cause me problems in the future? Should I redo it?



Thanks for any help.

It won't matter. There is a bit of wiggle room with the downward bend.

Thanks Bruce. I can sleep better now.

Just be sure there isn't going to be an edge distance problem with the longeron when the holes for the skin are drilled