miyu1975
Well Known Member
In trying to prep and drill the ribs and side skins and thinking of the ever impending canopy, I seem to have a possible misalignment and instructions and drawings aren't helping to much.. The sides of the F-631 channels extend past the roll bar...although this makes the 631 sides and WD 725 and skin flush to fuse..
At the top of the rollbar and 631s they are flush to each other.
In order to make the sides flush I had to extend both the 631 out a little..leaving a gap in the middle..
Thoughts...is the ok...is the canopy going to fit like this.?
At the top of the rollbar and 631s they are flush to each other.
In order to make the sides flush I had to extend both the 631 out a little..leaving a gap in the middle..
Thoughts...is the ok...is the canopy going to fit like this.?