Thank you for this suggestions. I am building a QB RV-9 slider and I had to drill out some of those handsome QB rivets to fit the upper front deck skin. As I was drilling I was wondering how I would get them back.
Quote:
Originally Posted by Desert Rat
Victory.
I looked at this again after sleeping on it and realized that the whole issue is that the aft lower edge of the forward canopy deck is in the way back there, and it's just a flange hanging in empty space.
Trimmed about 1/4" off it parallel to the longerons and suddenly I had enough room to get a 3/8" thick L shaped bucking bar in there.
Kudos to everybody who can stand on their head and use a screwdriver as a bucking bar, but I've tried stuff like that before and sad to say, thats a skill set thats hit or miss for me. this was eezy peeze.
Thanks for all the suggestions!
|
Linear Mode
