rapid_ascent
Well Known Member
I've been working on my wiring lately and I'm almost to the point of hooking up one side of my modular panel. On my copilot side I have a GDU450 and a couple of rows of circuit breakers. I routed some of the wires into the area behind that GDU450 and I'm ready to start making connections to the panel. I was trying to figure out the best way to route those wire bundles such that I would be able to pull the panel out and allow enough room to remove connectors and etc. I'm wondering what others have done? Did you just allow some extra length and not worry about supporting that length? I was a little worried about doing that. Did you make a loop with a cable tie and plan to clip it prior to removing the panel? Any thoughts and/or pictures would be helpful.