It says: "Dimple the #30 holes in the left inboard E-1022 Shear Clip as shown in Figure 1. Dimple only the left inboard E-1022 Shear Clip."
I notice that later on the Shear Clips will be riveted with AN470 rivets. Why dimple them here?
It's also not exactly clear to me that the two holes on the short flange are to be dimpled...or not.
Thoughts, anyone?
Thank you.
I notice that later on the Shear Clips will be riveted with AN470 rivets. Why dimple them here?
It's also not exactly clear to me that the two holes on the short flange are to be dimpled...or not.
Thoughts, anyone?
Thank you.