lndwarrior
Well Known Member
I just installed the Stratus ESG with the Stratus 3i and an ACK A-30 encoder.
Also installed a new Rami AV-801 (A) gps antenna.
I also purchased the complete wiring harness so all was plug and play.
The complete system was purchased thru RST Engineering (who gave me a great deal).
I did fabricate new RG-400 cables for the transponder and gps antennas.
I ran new static line to the encoder.
I input all of the setup info including flight number, hex code, etc., in the ESG.
Everything powered up normally.
I flew in rule airspace for more than 30 minutes.
I did get the "built in test" failure icon on the ESG.
I never got a pressure altitude indication.
I've attached the error portion of my report. I'd appreciate any suggestions to help me solve this problem.
TIA,
Gary
Also installed a new Rami AV-801 (A) gps antenna.
I also purchased the complete wiring harness so all was plug and play.
The complete system was purchased thru RST Engineering (who gave me a great deal).
I did fabricate new RG-400 cables for the transponder and gps antennas.
I ran new static line to the encoder.
I input all of the setup info including flight number, hex code, etc., in the ESG.
Everything powered up normally.
I flew in rule airspace for more than 30 minutes.
I did get the "built in test" failure icon on the ESG.
I never got a pressure altitude indication.
I've attached the error portion of my report. I'd appreciate any suggestions to help me solve this problem.
TIA,
Gary