HeliCooper
Well Known Member
My buddy and I are scratching our head over the best way to to rivet the side skin to the bottom of the foot well skin. The holes are partially obscured by the lower longeron and bucking access is very minimal. I didn't know if anyone had any suggestions here. We were at the end of a "didn't go so smoothly" riveting session and stopped here. The holes that are further aft will be right on the edge of tungsten angled bar. The forward holes I can get a footed bucking bar under the longeron but the middle ones are awkward.
Holes are on the left hand side running vertically
Holes are on the left hand side running vertically
Last edited: