David Paule
Well Known Member
That's the question. This is for an RV-3B which has a very small cockpit. I was amazed to realize just how many wires there were.
I've got a variety of things feeding up to the avionics panel, and they've got to pass through a bushing into the spar bulkhead's aft side. All together these are for a transponder remote box, an ADAHRS, a couple of autopilot servos, the lights, the headphone plugs and so on. After they've made it into the side of the bulkhead, they'll go to the avionics shelf.
I think the biggest wire is probably an 18 ga., but that's still slightly TBD so far. I think that there are a few shielded cables in the mix. There are no antenna cables in the bundle.
I'm putting together the armrest assembly on that side of this small RV-3B cockpit and the bundle will go into the side of the spar bulkhead below the armrest's bottom shelf, where there's not a lot of room.
Thanks!
Dave
I've got a variety of things feeding up to the avionics panel, and they've got to pass through a bushing into the spar bulkhead's aft side. All together these are for a transponder remote box, an ADAHRS, a couple of autopilot servos, the lights, the headphone plugs and so on. After they've made it into the side of the bulkhead, they'll go to the avionics shelf.
I think the biggest wire is probably an 18 ga., but that's still slightly TBD so far. I think that there are a few shielded cables in the mix. There are no antenna cables in the bundle.
I'm putting together the armrest assembly on that side of this small RV-3B cockpit and the bundle will go into the side of the spar bulkhead below the armrest's bottom shelf, where there's not a lot of room.
Thanks!
Dave