ron sterba
Well Known Member
I have built my panel ,that is all the cut outs are complete including the Dynon Skyview 10". Now its the fuse block I don't know much about. BandC aircraft supply has different quantity blocks with the car style fuses. These fuses have a LED light (I Am told) under them that lights up when blown. I don't exactly know what should all be fused and what value the fuses should be rated. My thoughts of fused would be the Skyview 10",radio,electric boost pump,flaps,lights, taxi ? Landing? Position, & LED strobes? 2-servos for autopilot? panel lights? Transponder? ADS-B unit? Engine probe unit from Dynon? back-up EFIS battery? Ahars unit? If you did a install with this style fuse block where would you recommend installing it? I'm think the Skyview,transponder,ADS-B unit and Engine monitor unit all on one EFIS switch but fused separately? Open to your designs! I have ten switches. Avionics master, boost pump, nav lights,strobe,taxi,landing,radio,auto pilot,panel lights,EFIS. Should there be more or less? I do have a separate ELT remote switch I'm told thats a stand alone unit anyway. Again open to your ideas and thoughts.
Thanks
Ron in Oregon RV9A N421HJ
Thanks
Ron in Oregon RV9A N421HJ