Drilling holes isn't a problem, but drilling them centered on the diameter is. I've found various jigs online, but they all are of specific drill sizes and so far, none of the sizes we use.
Then, there're the slots that must be cut in the L and R pushrods for the canopy release. A handheld dremmel could work, but it would be clunky and might not cut straight.
The figure shows what I'm talking about if the explanation wasn't clear.
Then, there're the slots that must be cut in the L and R pushrods for the canopy release. A handheld dremmel could work, but it would be clunky and might not cut straight.
The figure shows what I'm talking about if the explanation wasn't clear.
Last edited: