I need to make sure I'm looking at this correctly. The plans call for the canopy side rails to be 1/16" inside the fuse profile. The plans also call for the rear bow to be inset about 1/16" relative to the aft top skin. I'm having problems maintaining both of these dimensions in the area where the rear bow is welded to the side rails because the bow is welded to the "inside" of the side rail, as seen here:
[/URL][/IMG]
Am I not thinking about this correctly? Any guidance on the reality of maintaining both dimensions would certainly be appreciated.
Thanks for the help!
Am I not thinking about this correctly? Any guidance on the reality of maintaining both dimensions would certainly be appreciated.
Thanks for the help!