Hello All,
Today we wanted to drill our Vertical Stabilizert to the Fuselage of our RV-8.
We went through the Steps in the Instruction till....
...we found that the drawing shows a wrong measurement. Please, see picture below.
Had anybody else this issue?
What should the correct measurement be - instead of the 7/8 inches?
Maybe somebody has an updated drawing?
Thanks a lot for your help!
Best regards,
Anna
[/url][/IMG]
Today we wanted to drill our Vertical Stabilizert to the Fuselage of our RV-8.
We went through the Steps in the Instruction till....
...we found that the drawing shows a wrong measurement. Please, see picture below.
Had anybody else this issue?
What should the correct measurement be - instead of the 7/8 inches?
Maybe somebody has an updated drawing?
Thanks a lot for your help!
Best regards,
Anna