ShortSnorter
Well Known Member
Long story short, my Van's factory wiring harness has shielded wire run from the tail of the plane to the panel. When building my panel harnesses, the ELT was not taken into consideration and omitted somehow.
I used my last RS-232 Out avaialbe on my GDU and made the connection with some spare AWG 20 to the Vans harness and did a quick test at the ELT using the LED light "blinking" - Success!
Question: Are there any concerns from running non shielded wire from the GDU to the Van's harness (I don't have any shielded wire on hand)?
Oh & Merry Christmas!!
I used my last RS-232 Out avaialbe on my GDU and made the connection with some spare AWG 20 to the Vans harness and did a quick test at the ELT using the LED light "blinking" - Success!
Question: Are there any concerns from running non shielded wire from the GDU to the Van's harness (I don't have any shielded wire on hand)?
Oh & Merry Christmas!!