Both side skins on complete with arm rests!
Mating the forward and mid cabin together was a bit of a chore for 1 person but I managed.
Then came the forward skins.
The obligatory "Looks like an airplane"...
Everything fit reasonably well. The forward skins were challenging where they mate up with the side skins and center section which I hope match drilling will help with. The side skins also have a slight wave in them at the top which concerns me but I have been advised it will all sit nicely when rivets and the longerons come into play. I hope so...
On to the rear bulkheads. Carefully cut this angle into 5 or so parts.
The WD-409 and its instructions were vague and this is a CRITICAL step. Misdrill here and your tailwheel will be permenantly out of alignment. I had to read several builders sites to make head or tails of it. I am still not completely comfortable with the instructions because the builder sites say there has been a revision to the plan dimensions. Van's must have not corrected this issue because I have the old dimensions listed on my plans. Hoping for the best and building on here.
Cleaned and prepped for primer.