Everything has gone together so beautifully I dont even worry about it. When I got the Roll bar assembly ready to slide on to the F1231D roll bar base, it was about 5/16" too narrow. I drilled out some rivets, spread it, and now its only about 3/16" too narrow. I can force it on to the mounts with 90 lbs force spreading it apart (edited).
Should I drill out more rivets and tweak it untill it does not put a load on the fuse?
Should future builders clamp it onto a table and hold the dimension between the F-1231D roll bar bases before riveting it? It seems like that would also eliminate possible warping, which I have a bit of.
Should I drill out more rivets and tweak it untill it does not put a load on the fuse?
Should future builders clamp it onto a table and hold the dimension between the F-1231D roll bar bases before riveting it? It seems like that would also eliminate possible warping, which I have a bit of.
Last edited: