jrock836
Well Known Member
Turned on the Master and my Skyview Classic didn’t boot up. The master switch light didn’t turn on either, but I could hear one of the fans turn on. I then pressed button 1 on the Skyview, which then started the boot up. Once booted up, buttons 1 and 2 don’t work in any menu.
I don’t remember if it’s normal, but the Master Switch light turned on as the Skyview display illuminated. There’s one point in the boot up process where the screen goes dark which is normal. But I did notice that when the screen went dark, the master switch light turned off and then turned on as the Skyview display flashed back on.
Any ideas what in the heck is going on? The battery seems to be okay. I was able to start the plane.. I hope I can get this figured out. I was hoping to fly to Oshkosh in a few weeks. I asked my question on the Dynon forum too. Yes MOD, I intentionally put this in the RV12 forum because I’m not sure if this is an RV12 wiring issue, or a Skyview issue.
I don’t remember if it’s normal, but the Master Switch light turned on as the Skyview display illuminated. There’s one point in the boot up process where the screen goes dark which is normal. But I did notice that when the screen went dark, the master switch light turned off and then turned on as the Skyview display flashed back on.
Any ideas what in the heck is going on? The battery seems to be okay. I was able to start the plane.. I hope I can get this figured out. I was hoping to fly to Oshkosh in a few weeks. I asked my question on the Dynon forum too. Yes MOD, I intentionally put this in the RV12 forum because I’m not sure if this is an RV12 wiring issue, or a Skyview issue.
Last edited: