Searched for photos and tips but no joy.
My AEROLED Pulsar NS Navigation Lights and Suntail are NAV/Strobe LEDs. The instructions for installing are posted below.
For those that have gone before me (many I'm sure)
How did you gang the shield grounds near the switch location??
I've experimented with various ways to solder the shield to a single pigtail but it's bulky and looks terrible. The factory recommended soldering with a solder sleeve but none of the ones I have are big enough to go around three 3-20 wires.
In the photo you will see the three 3-20 cables coming from the left, right and tail lights. The instrument panel is removed so I can have some working roo. The switches would be just a few inches away from the stripped sections.
My AEROLED Pulsar NS Navigation Lights and Suntail are NAV/Strobe LEDs. The instructions for installing are posted below.
For those that have gone before me (many I'm sure)
How did you gang the shield grounds near the switch location??
I've experimented with various ways to solder the shield to a single pigtail but it's bulky and looks terrible. The factory recommended soldering with a solder sleeve but none of the ones I have are big enough to go around three 3-20 wires.
In the photo you will see the three 3-20 cables coming from the left, right and tail lights. The instrument panel is removed so I can have some working roo. The switches would be just a few inches away from the stripped sections.