LettersFromFlyoverCountry
Well Known Member
I know this is a stupid question but I'm beyond being concerned about that. .
I just made the ELT end connection in a dsub connection for my ARTEX 406 ME ELT. So now I've got two plastic shells (I can figure out how those go together) and a bunch of screws nuts and a couple of tabular gizmos and I have no idea how they all fit together.
Can someone point me to a diagram for how a typical DSUB shell is assembled?
Also -- in the event someone has installed one of these -- can someone confirm that a ground wire from pin 7 of the ELT-end connector is spliced onto the the shielding and then is connected by a similar method at pin 6 of the remote switch connector, and then a wire is run from pin 9 to local ground?
Here's the manual. I want to make sure I'm reading iit correctly.
I just made the ELT end connection in a dsub connection for my ARTEX 406 ME ELT. So now I've got two plastic shells (I can figure out how those go together) and a bunch of screws nuts and a couple of tabular gizmos and I have no idea how they all fit together.
Can someone point me to a diagram for how a typical DSUB shell is assembled?
Also -- in the event someone has installed one of these -- can someone confirm that a ground wire from pin 7 of the ELT-end connector is spliced onto the the shielding and then is connected by a similar method at pin 6 of the remote switch connector, and then a wire is run from pin 9 to local ground?
Here's the manual. I want to make sure I'm reading iit correctly.