The photo shows the IP layout so far. Since I haven't purchased the instruments or cut holes, I thought this might be a good time to post and let others tell me what they think. I recognize everyone has their own favorite layout, so in the spirit of learning, I appreciate all feed back. It is intended to be IFR capable.
By way of explanation, I have chosen to go with Garmin G3X and all Garmin supporting cast. Instead of a GTN650 or 750 I plan on a remote mounted GPS20A (ADSB WAAS certified position source) feed to ADSB out, both MFDs with seperate GNC255a nav/com and GTR200 com radios. The cost is about $4K less total and I don't need another screen. I also wanted to leave space in the lower center stack to mount an ipad (removable and exchangeable as technology changes).
All of the switch plates are laser etched second surface (etched from the back in black coated clear stock) and backlit.
Leo
By way of explanation, I have chosen to go with Garmin G3X and all Garmin supporting cast. Instead of a GTN650 or 750 I plan on a remote mounted GPS20A (ADSB WAAS certified position source) feed to ADSB out, both MFDs with seperate GNC255a nav/com and GTR200 com radios. The cost is about $4K less total and I don't need another screen. I also wanted to leave space in the lower center stack to mount an ipad (removable and exchangeable as technology changes).
All of the switch plates are laser etched second surface (etched from the back in black coated clear stock) and backlit.
Leo