vmirv8bldr
Well Known Member
I had my panel cut, but the about half the holes need to be enlarged a fair amount. I went with a TruTrak AP, and selected the Flat Pack control head. However, to delay expense as much as possible, I don't physically have the head yet. So, does anyone have the dimensions for the cutout in the panel for a DGII Flat Pack? I looked all over TruTrak's website and didn't see it, and I searched here for quite a while to no avail.
If anyone has this head laying around and could measure for me, I would be grateful.
Thanks,
Bart
If anyone has this head laying around and could measure for me, I would be grateful.
Thanks,
Bart