View Single Post
Old 05-03-2009, 10:29 AM
vmirv8bldr's Avatar
vmirv8bldr vmirv8bldr is offline
Join Date: Jun 2005
Location: Eastvale, CA
Posts: 378
Default Trutrak flat pack cutout

I had my panel cut, but the about half the holes need to be enlarged a fair amount. I went with a TruTrak AP, and selected the Flat Pack control head. However, to delay expense as much as possible, I don't physically have the head yet. So, does anyone have the dimensions for the cutout in the panel for a DGII Flat Pack? I looked all over TruTrak's website and didn't see it, and I searched here for quite a while to no avail.

If anyone has this head laying around and could measure for me, I would be grateful.

Bart Filipiak
Eastvale, CA
RV-8 N74VB

Barrett IO-390
Reply With Quote