Need help with SJ cowl!!!
View Single Post
11-26-2011, 10:06 PM
Join Date: Jun 2005
Location: Eastvale, CA
This may help explain what I'm seeing...
I checked my engine mount at the fuselage and it is symmetrical and centered. All bolts are torqued. 2.5" prop extension is installed as required by the SJ cowl for the RV-8.
In the pic below, I used a long level to extend the fuselage forward to the engine and then measured these values from the edge of the level to the center of the valve cover of each cylinder.
View Public Profile
Send a private message to vmirv8bldr
Find all posts by vmirv8bldr