View Single Post
  #4  
Old 02-08-2021, 08:09 AM
Jamesey Jamesey is offline
 
Join Date: Feb 2008
Location: Hartlepool, England
Posts: 195
Default

Tony,
"No expert, but the Garmin radio communicates with Skyview via a serial port. Have you checked the serial ports setup menu to see if the GTR 225 is specified on one of the ports?"

From the Dynon Skyview Manual the following options selected:
Configure the serial port: SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL
PORT x SETUP > SERIAL IN DEVICE > (Configured for Serial Port 4)
FUNKE ATR833 or
GARMIN GTR 200 or
Full TY91/92 8.33 kHz support depends on a future software update from Trig.
SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration
SkyView System Installation Guide – Revision W 4-23
GARMIN GNC 255 A/B or
GARMIN GTR 225 A/B or (This radio selected)
TRIG TY9X 25KHz ONLY
TRIG TY9X 8.33/25KHz
This will automatically set the SERIAL IN FUNCTION, SERIAL IN/OUT BAUD RATE, and SERIAL
OUT DEVICE.
Set the radio status to be displayed on the top bar: SETUP > SYSTEM SETUP > DISPLAYED COM >
(device you chose above) (PORT x) (“DISPLAYED COM” does NOT appear as an option. It has a setting for “PRIMARY COM” which shows GARMIN GTR 225 A/B selected on Serial Port 4)
and
SETUP MENU > SYSTEM SETUP > DISPLAY COM IN TOP BAR: YES (This option selected)

Still searching
Reply With Quote