View Single Post
  #1  
Old 05-26-2008, 08:55 PM
danielhv's Avatar
danielhv danielhv is offline
 
Join Date: Jul 2007
Location: Mesquite, TX
Posts: 936
Default Edge distance after repair... (R-710 again)

I made the repair recommended here, but now looking at the part after clecoing in place, I am concerned about edge distance for the affected area. The plans are calling for AN426AD3-4's which require a 0.156" edge distance. In the spot I made the repair, the "low point" is .1350"... everything else is in the green, just the one low spot. Suggestions?

Reply With Quote