View Single Post
  #3  
Old 01-15-2021, 10:03 AM
Bart Bart is offline
 
Join Date: Jan 2008
Location: Pecan Plantation (0TX1)
Posts: 195
Default

I also found that installing the wires works best to remove the plug and then install and tighten. That's not really my question - My hurdle has been installing the inside of the two anchor screws on the plug. The outside one is very accessible and easy, the inside one sits under the B&C. A very difficult access point. Just curious if someone else has had the same trouble with a B&C on the rear pad.
Reply With Quote