Gents,
On Section 21 Page 6 Step 5 - hinge bracket assembly
I have read thru these instructions and see in step 5 that an AN4-7 is to be inserted into the ".250" holes. An AN4 - will not fit in this hole without re-sizing. I fear perhaps I missed a step in the instructions (although I did read several times...) or that the part was to be supplied with a .250 hole but wasn't.
Shall I drill it or ream it to .250? Any specific instructions for sizing this hole?
Hardware call-out can be seen on 21-12, figure 3.
Thanks,
On Section 21 Page 6 Step 5 - hinge bracket assembly
I have read thru these instructions and see in step 5 that an AN4-7 is to be inserted into the ".250" holes. An AN4 - will not fit in this hole without re-sizing. I fear perhaps I missed a step in the instructions (although I did read several times...) or that the part was to be supplied with a .250 hole but wasn't.
Shall I drill it or ream it to .250? Any specific instructions for sizing this hole?
Hardware call-out can be seen on 21-12, figure 3.
Thanks,