RV-12iS with 2 G3X screens and a G5 standby instrument.
After firmware 9.12 I got a Roll Servo hardware fault.
I then updatet to firmware 9.14 and things were ok on the ground but on a flight today I got two faults.
First the right G3X went black for 5 min, came back on but with touch fault. I could not change anything on the screen.
The Roll Servo fault also came back.
On the ground with a power reset the G3X seems to work again but the Roll Servo hardware fault is still active.
I am not sure what to do?
After firmware 9.12 I got a Roll Servo hardware fault.
I then updatet to firmware 9.14 and things were ok on the ground but on a flight today I got two faults.
First the right G3X went black for 5 min, came back on but with touch fault. I could not change anything on the screen.
The Roll Servo fault also came back.
On the ground with a power reset the G3X seems to work again but the Roll Servo hardware fault is still active.
I am not sure what to do?