View Single Post
  #1  
Old 04-14-2020, 05:59 PM
Coaltowngarage Coaltowngarage is offline
 
Join Date: Aug 2019
Location: Altoona,AL
Posts: 49
Default Aluminum angle material substitute?

Building this early 90s kit. Was passed around a bit over the years. As you can imagine...theres stuff missing. On my plans, it calls for an aluminum angle 1 inch by 1 1/4 by 1/8 that runs from the lower corner of the firewall to the wing spar bulkhead 604. I see on vans website they do not carry a 1 x 1.25 x. 125 angle. I appears that vans no longer offers this size angle. Does anyone know of an acceptable replacement material for this section? It appears to be the only place on the plane that this dimension material is called for.
Reply With Quote