View Single Post
  #5  
Old 12-31-2011, 09:10 AM
Don at Airflow Don at Airflow is offline
 
Join Date: Jun 2006
Posts: 316
Default Cable ends

We prefer using rod end bearings on all control cables (throttle, mixture, purge valve). It not only gives a almost bullet proof connection but also gives good operation if the cable has some offset to the lever. There are plenty of examples of these connections in the appendix section in your Installation and Service Manual. If you need more examples email me at don@airflowperformance.com, and I can send you more ideas from installations we did at our facility.

Don
Reply With Quote