View Single Post
  #2  
Old 01-18-2021, 07:23 AM
John-G John-G is offline
 
Join Date: Jan 2012
Location: Northeast Ohio
Posts: 742
Default

I'm pretty sure my initial marking of the tail cone fitting was done with the tail feathers off. Then at some point they were installed because I do remember doing the drilling for the nutplate screw and rivet holes with the tail feathers on.

Sixth photo in this blog post:
http://www.dogaviation.com/2015/06/p...for-final.html

Beginning with the third photo in this post:
http://www.dogaviation.com/2016/03/c...-resolved.html

Hope that helps .... happy building.
__________________
John
http://www.dogaviation.com/

RV-12 Wings, Empennage, Fuselage, Finishing, Avionics and Powerplant kits all completed
Now Flying!!

Donation paid until September 2021
Reply With Quote